As a standard in the industry, industrial vacuum cleaners are not to be underestimated. Using a better industrial vacuum cleaner can absorb dust and air waste from the production site during the industrial production process, improve the quality of some products.
Quality Industrial Vacuum Cleaners will ensure the surrounding air is fresh, and avoid some damage to employees due to dust, thereby reducing The production cost of industrial enterprises.
So, what matters should be paid attention to when using
industrial vacuum cleaners?
When using an industrial vacuum cleaner, the suction control device can be adjusted appropriately depending on the situation to be cleaned. After using for a period of time, due to the excessive accumulation of dust on the filter, the suction power will decrease. At this time, the filter can be removed and blown back with compressed air to restore the suction. If the suction cannot be restored after cleaning, the filter needs to be replaced.
Moreover, various industrial vacuum cleaners of different models and specifications have different structural performance and functional characteristics. Therefore, it is necessary to read the instruction manual carefully before using the selected vacuum cleaner to avoid damage to the vacuum cleaner and endangering personal safety due to improper use.
Before using the vacuum cleaner, you should first connect the hose to the suction port of the housing properly. The hose should be screwed tightly to each section of the super-long nozzle and the nozzle at the end of the nozzle, such as furniture brushes, crevice nozzles, and floor brushes. Since there are fewer air inlets from the slit nozzle, the noise is higher during use, and the continuous use time should not be too long. Industrial vacuum cleaners should be used in a dry room or similar environment where the altitude does not exceed 1,000 meters, the environment is well ventilated, the ambient temperature does not exceed 40°C, and there is no flammable or corrosive gas in the air. Connect the ground wire to ensure safe electricity use. Before use, check whether the line is connected well, whether there is any leakage, etc., and then use it after confirming that it is intact.
In normal use, be careful not to get the vacuum cleaner with water, and you cannot operate the machine with wet hands. If there are large pieces of paper, paper balls, plastic cloth or something larger than the diameter of the straw in the area to be cleaned, they should be removed in advance, otherwise, it will easily block the nozzle pipe. Puyi Environmental Protection has a PY series that can absorb dust and water.
When it is found that there is a lot of garbage in the dust storage tank, remove the dust on the filter while removing the garbage, and maintain a good ventilation channel to avoid blocking the filter and causing the suction power to not drop, the motor to heat up, and the service life of the vacuum cleaner.
When using a vacuum cleaner with an automatic cord reeling device, pull out the power cord for a sufficient length of use. Do not pull the power cord too far. If you see a yellow or red mark on the power cord, stop pulling it out. When you need to rewind the power cord, press the button to automatically retract it.
After the industrial vacuum cleaner is used, it should be stored in a dry place. If it is placed in an excessively humid place, it will affect the electrical insulation and service life.
Publication Date: 26 August, 2020
Category:
Industrial Vacuum Cleaner
